Skip to content

Furniture from original aircraft parts. Made in Italy.

Request
information
Three-engined airliner · 1962–1984 · 1,832 built

Boeing 727 cowling reception desk, mirrors and bar shelving

Of the five pieces that come from the 727, four are engine cowlings and one is an emergency exit door. The cowlings can only come from two of the three engines: the third, the centre one, is buried inside the tail and has no cowling that can be taken off.

The pieces that come from it

5 in the catalogue

The Boeing 727 first flew on 9 February 1963 at Renton, Washington, and entered service on 1 February 1964 with Eastern Air Lines on the Miami–Washington– Philadelphia route. Production ended in September 1984: the last aircraft went to Federal Express. 1,832 were built in all. For some twenty years it was the best-selling airliner in the world, until the 737 overtook it in the early 1990s.

Why three engines, and why there are two cowlings

In the early 1960s the engine available for an aircraft of that class was the Pratt & Whitney JT8D, giving between fourteen and sixteen thousand pounds of thrust. To lift a hundred and thirty passengers off a short runway, and keep climbing after losing one, three were needed. Putting them all in the tail left the wing clean, with no pylons and no nacelles.

But the three engines are not mounted the same way, and this is where it bears on the pieces on this page. Engines 1 and 3 sit in two nacelles on the sides of the rear fuselage: real nacelles, cylindrical, with hinged doors that open for maintenance. Engine 2, on the other hand, is buried in the fuselage ahead of the fin, and breathes through an intake at the base of the rudder that carries the air down to it in an S-duct. Around the centre engine there is no nacelle: there are fixed cowling panels, part of the structure of the tail.

Hence the conclusion, which we state for what it is: it is reasoning, not a citation. No document says «only nacelles 1 and 3 can be recovered». The geometry of the aircraft says it. A 727 cowling that is still a finished object after stripping comes from a side engine, not from the centre one.

The engine that holds three different aircraft together

The Pratt & Whitney JT8D entered service on the 727 itself, in 1964. More than 14,750 were built, accumulating over 673 million flight hours. In the standard series (the 727's) the casing is 40 inches in diameter, a little over a metre, by 3.14 m long, and it weighs between 1,454 and 1,543 kg dry. The bypass ratio is only 0.96 to 1: almost half the air goes through the hot core. It is a loud engine, and further down this page you will see how much that counted.

The same engine, almost unchanged, also powered the Douglas DC-9 and the Boeing 737-100 and -200. The collection contains pieces from all three: this is why the 727 cowlings, the DC-9 ones and the 737 fans resemble each other more than you would expect from aircraft of three such different shapes.

And they resemble each other in size too. The 727 cowling pieces in the collection are between 122 and 128 cm in their largest dimension; the DC-9 cowlings are 130 cm in diameter. They are two different aircraft, a two-hundred-seat trijet and a hundred-seat twinjet. But the piece is almost identical, because what decides the size is not the aeroplane: it is the engine inside it, and the engine is the same.

The data plates, and how long it takes

Plate on the green engine cowling: AIRCRAFT MOD. 727, MFR. CODE RR, PART NO. 65-19685-4541, SERIAL NO. 3202, with the round ROHR stamp in the inspection box.
The 727 plate with the Rohr stamp, the company that built the nacelles

On the 727 cowlings the plates are there, and they are of two kinds. The first is the Boeing form: AIRCRAFT MOD. 727, MFR. CODE RR, and a part number in Boeing's classic form, 65-19685-4541 on one, 65-19685-4332 on another, with serials 3202 and 882. In the inspection box is the stamp ROHR: the 727 nacelles were built by Rohr Industries, in California.

Plate from Burbank Nacelle Corp., Burbank, California, part number 727-22000-476, and beside it, stencilled on the metal: ELIGIBLE FOR BOEING 727-200.
«Eligible for Boeing 727-200», stencilled on the metal

On a third piece the plate is from another supplier — Burbank Nacelle Corp., Burbank, California, PART NO. 727-22000-476, SER. NO. 12146 — and beside it, stamped into the sheet, is what closes the question without any deduction at all: «ELIGIBLE FOR BOEING 727-200».

Polishing follows the same cycle as the DC-8 (nine or ten passes, the titanium rivets treated separately), but over a smaller surface: Carlo puts it at around half the time of a DC-8 cowling, so in the order of fifty hours.

Plate on the emergency exit door: AIRCRAFT MOD 727, PART NO 50-7978-90, SERIAL NO FN 3264, on the same form as the engine cowlings.
The plate that corrected the catalogue: the door is from a 727

This family also includes a piece the catalogue attributed to another aircraft: the emergency door AIR-DOR0198, which is from a 727 and not from an ATR. The plate says so: AIRCRAFT MOD 727, PART NO 50-7978-90, SERIAL NO FN 3264. It is one of the corrections to the catalogue.

The door

Emergency exits on airliners do not have a free size: the regulation divides them into types, and each type has a minimum dimension. Type I is at least 61 × 122 cm, Type II at least 51 × 112, Type III at least 51 × 91, Type IV (the one over the wing) at least 48 × 66. Our door measures 52 × 103 cm: it falls within Type III, which on the 727 is the overwing exit.

That is a deduction from the measurement, not a line read off a manual, and we write it as such. What can be said without reservation is that it is a real door, built to be opened once in the life of an aeroplane, and that almost always it never was.

The law that grounded the fleet

The 727 did not leave the stage because it was worn out. It left because of a law, and that law is the reason there are pieces to recover today.

On 5 November 1990 the United States passed the Airport Noise and Capacity Act (Public Law 101-508). The noise regulation, 14 CFR Part 36, divides aircraft into stages: aircraft of the 727's generation are Stage 2. The law established that after 31 December 1999 a civil jet may no longer fly in the United States unless it meets Stage 3 levels. In Europe came Regulation 925/1999, which from 1 April 2002 closed Community airports to «recertificated» aircraft, that is, quietened with add-on devices.

Anyone who wanted to keep them flying had to quieten them. The hush kits for the 727 were done in three different ways: Valsan re-engined them (a project later taken over by Rohr and renamed Super 27); Federal Express designed its own kit in house and by the end of 2003 had orders for 740 aircraft from sixty operators, at about three million dollars each and twenty-one days of work apiece; DuganAir sold a system of wingtip devices. For a courier grinding out night flights the sums worked. For a passenger airline, almost never.

The rest is chronology. FedEx (the largest 727 operator in the world, with up to a hundred and seventy aircraft) retired its last on 21 June 2013 at Memphis. The last 727 passenger flight in the world was on 13 January 2019: Iran Aseman EP851, Zahedan to Tehran, with an aircraft delivered to Air France in 1980.

The vane named after a man who was never found

The 727 had a ventral stairway that lowered from the tail. On 24 November 1971, on Northwest Orient flight 305 between Portland and Seattle, a man booked as Dan Cooper had two hundred thousand dollars handed to him, let the passengers off, ordered the aircraft back into the air and jumped from that stairway in flight. He was never found.

On 20 June 1972 the FAA published the proposed amendment to 14 CFR 25.809: neither the ventral exit nor the tailcone exit must be openable in flight. Since then every 727 has carried a spring-loaded aerodynamic vane that the airflow pushes into the locked position: it is called the Cooper vane, and it is named after a man whose real name is not even known. It is the rare case of a design change named after the problem instead of after the person who solved it.

Why the 727 could land where others could not

Two details explain its career. The first is the wing: triple-slotted flaps on the trailing edge and slats and Krueger flaps on the leading edge, an extraordinarily complicated arrangement that let it use runways of a little over thirteen hundred metres. The second is that it was the first Boeing airliner to carry an auxiliary power unit as standard: with the APU for electricity and air conditioning and its own airstairs for boarding, it needed no ground equipment at all. It could stop at airports that had nothing. That is how it opened hundreds of secondary airfields.

What gets polished, and where it goes wrong

The aircraft sheet of those years is almost always Alclad: a high-strength aluminium alloy, usually 2024, with a thin layer of nearly pure aluminium hot- rolled onto it, protecting the core beneath from corrosion. That layer is thin: between 1 and 15 per cent of the total thickness of the sheet.

This has a practical consequence worth writing down: polishing can go through the pure aluminium layer and reach the alloy underneath. It looks just as bright on top, but the corrosion protection is gone. It is the reason polishing aircraft sheet is not a job of force.

It should also be said here that no public document specifies the exact alloy of the 727 cowlings: Alclad 2024 is the standard of the period, not a citation from a Boeing drawing.

The evidence

The plates and markings photographed on the pieces. They are what this page rests on: where there is no plate, the page says so. The serial number visible on each of them belongs to the component that was photographed: every piece carries its own, and it is written on the certificate that comes with it.

Sources for this page
  1. Boeing — Select Products in Boeing History (production)
  2. HistoryLink.org — the 727’s first flight, 9 February 1963
  3. The Museum of Flight — Boeing 727-022, the first one built
  4. Pratt & Whitney (RTX) — the JT8D engine
  5. 49 U.S. Code § 47528 — the Stage 3 deadline
  6. FAA — Aircraft Noise Levels & Stages
  7. EUR-Lex — Regulation (EC) 925/1999 on hushkitted aircraft
  8. FedEx — the retirement of the last 727, 21 June 2013
  9. Smithsonian Air & Space — what hush kits are
  10. AeroTime — the FAA change after the 1971 hijacking
  11. World Airline News — the last passenger flight, 13 January 2019
  12. Alclad — what clad sheet is

The pieces that come from it ↑